People may not know it well. It is a tool used in industry, which is of great help to our industrial production. But we need to pay attention to the daily operation of waterjet, do you understand? If you don't understand the operation of waterjet, you should get to know it with the editor. I believe you will gain a lot.

Precautions for waterjet operation:

1. After the blast nozzle has been used for a period of time, rotating an angle can greatly increase the service life of the blast nozzle.

2. Please do not try to buy parts that are not provided by the manufacturer at a low price. Not only can you not get the quality of the parts, but it may also damage your equipment and cause greater losses. At the same time, you will also lose the manufacturer's warranty on your equipment, which is not worth the loss.

3. The user can back up the parameters in the CNC system for restoration when necessary.

4. When the user cannot determine the cause of the fault after the fault occurs, please observe the fault phenomenon in detail and report it to the waterjet customer service staff. Under the guidance of the customer service staff, analyze and determine the cause of the fault and eliminate it.

5. Do you know how to quickly determine which end of the high and low pressure check valve is not well sealed? In fact, we can touch the high and low pressure parts at both ends with both hands. The sealing effect of the high temperature end is definitely not good.

6. In order to prevent water leakage when the steel pipe is connected, the thread of the steel pipe head must be three teeth higher than the thread pad.

7. If it is impossible to determine whether the problem lies in the water circuit or the oil circuit when a malfunction occurs, you can cut off the water circuit part, then turn on the oil pump and high-pressure water switch, and observe whether the cylinder piston changes normally. Determine whether the problem is a water failure or an oil failure.

8. After the normal start, keep pressing the button to turn on the high-pressure water, the device will stop reversing and display high pressure. If the oil pressure gauge can rise to the actual pressure, it can be determined that the relief valve is normal.

9. When the equipment is normally turned on but not reversed, we can remove the two electrical plugs on the reversing valve, and then replace the valve cores in the rubber caps at both ends of the reversing valve by hand. If the equipment can be reversed again, it can be confirmed that the reversing valve is normal.

10. When the turbocharger is started after maintenance, in order to protect the equipment, the pressure needs to be reduced first, and then slowly increased to the working pressure.

11. Where the seal ring is installed on the supercharger, grease should be applied during installation.

do you understand? Although the description is not very detailed, I hope it will be helpful to you.